Camshaft (Stage 2 Tune) 900cc early type Street Twin / Street Cup / T100 – Water-cooled
£360.00
IMPORTANT – READ BEFORE BUYING – The product is strictly for off-road/race/demonstration use only. It is not road legal for emissions in the EU or the UK. It is the customers responsibility to use this item responsibly to comply with local laws. These parts are not BS-marked, E-marked or TUV-approved.
IMPORTANT- THIS CAM ONLY FITS CERTAIN 2016> 900cc WATER COOLED BIKES – EARLY CHASSIS NUMBERS ONLY – SEE BELOW FOR DETAILS
Any doubts please contact us directly before purchasing.
REPLACES TRIUMPH CAMSHAFT NUMBER T1147004 ONLY (USA PART NUMBER T1147504)
The below VIN numbers are relevant in the UK ONLY. If outside the UK, we recommend checking with your Triumph dealer to see which camshaft is installed in your bike, before proceeding.
Check your bikes VIN number and make a note of the final 6 digits. If your final 6 digits are numerically lower than the below numbers then the cam will fit.
(VIN NUMBERS LAST 6 DIGITS)
Water-cooled T 100 – all VIN numbers up to VIN 818589
Street Twin – all VIN numbers up to VIN 818609
Street Cup – all VIN numbers up to VIN 818597
This is a Stage 2 fast-road tune camshaft for the early water-cooled 900cc Twins.
It has the same lift as our Stage 1 camshaft but with longer duration to give better breathing above 4,500 RPM and better peak horsepower.
Made exclusively for TEC in ENGLAND from CNC machined steel billet and fully heat treated for maximum durability.
Fully covered by manufacturers backed 12 month warranty.
The cam is now perfectly matched to the motor for road use with no loss of bottom end torque and a progressive power curve with increased performance and still has the same MPG.
As this is a performance camshaft, you may find power benefits from ECU remapping or a power commander etc. But this is not essential, it will run with the stock ECU.
This cam cannot be used in bikes with higher VIN or Street Scrambler, These bike use triumph cam T1147042, please see our other cam listing for details.
The below video gives a guide on how to fit the camshaft:
The video is a guide only and I would suggest using it along side the workshop manual from Triumph or Haynes.
Part numbers:
alternator cover gasket – T1268765
CAM screws T40 head – T3053005
Cam tensioner O rings – T3600199 + T3601276
Tightening torques
Cam sprocket screws 22 NM
camshaft bearing carriers 10Nm
Head top cover 14Nm
Alternator cover bolts 10Nm
Cam tensioner 16NM
