Alloy Tail Tidy / Rear Fender Eliminator Kit for Street Scrambler, Street Twin, Street Cup
TEC Tail tidy rear fender eliminator kit for Street Twin, Street Cup, Street Scrambler.
The kit includes a thick laser cut alloy under seat plate which is fully powder coated.
All required nuts, bolts, spacers and washers included.
E-marked Euro-legal Bright LED Lucas style rear stop and tail light.
Includes sleeved wiring to suit aftermarket lights and indicators with wiring connectors.
Unlike other tail tidy kits on the market our kit runs the full length under the seat and extends and curves down to the sides to help prevent water ingress and to protect the seat lock and cable. The alloy is fully powder coated for durability.
Indicator mounts easily removed if you want to mount them on shocks.
Some kits we have seen for sale are made of weak plastic or leave the lock or lock cable exposed this is not good for security!
Important- We do not include indicators in the kit due to hundreds of styles widely available online and everyone’s personal taste being different. So we leave the choice to yourself.
The kit is fully compatible with standard seats or Triumphs aftermarket flat dual seat and pillion seat pad.
Our TEC luggage rack can also be fitted with the Tail tidy kit.
If you want to use the 2 Hole OE type indicators we make an adaptor kit, please see our other items.
Out of stock
Want to be notified when this product is back in stock?
Well made and mechanically straight forward to fit wiring not perfect but not a major problem, all in all it is a big improvement to the back end , no number plate light on Lucas style tail light so that will need doing before next MOT good service from Tec as usual.
Bob on no probs at all bike starting to look like it should
easy to fit, nice quality and the loom means no modifying the original wiring, although the tail light blue and red wires needed swapping over as the brake light was permanently on. Also there is no licence plate light incorporated into the lucas tail light which may bother some people but I am told this is not a MOT requirement. I recommend fitting with the TEC bullet indicators to complete the look plus you can leave the stock indicators on the original fender for quick change back if required. you won't need the resistors for LC triumphs as you can alter the flash rate on the dash ( even if you have a combination of led and stock ) you tube will show you how to change the flash rate on the dash. I give 4 stars only because of the wiring error on the loom.
Good quality part and a perfect fit for my street twin.Did have a problem with the connect block that came with the tail light it wouldn’t power the indicators . I used the original block and connector and solder the rear light into the original wires
Very prompt delivery, easy to read and understand instructions and really good quality. In general its really good and definitely improves the look of the bike. Couple of minor comments that if they could be resolved would make it even better.
*I retained the stock indicators which have very short wires. Using the connectors provided in the package I soldered up extensions to reach the wires provided. However the connectors at the indicator ends are left half in half out of the tail tidy and are not neat. See Pic
*The rubber gasket is not easy to "fit" I glued it to the Light to make sure before fitting. A one piece covering the whole of the back of the light with holes for the fixing bolts would locate it perfectly.
* The number plate taken off the original fitting did not fit onto the new one. I had to drill new holes 1/3 inch higher up the plate to get it fitted under the light. See Pic